Tool traveling and tool switching time constitute almost seventy percent (70%) of the total timeconsumed in drilling process. This fact that 70% of the total time is nonproductive and does not add any value to the job, grabs attention of the researchers and the industrialist for optimization. A literature on drilling process revealed that very few ...

By Mehmood Nasir, Muhammad Umer, Umer Asgher

Risk management throughout the project life cycle, from the initial phase beginning to the final phase, ended continuously and dynamically, is one of the basic requirements for the success of any project oriented organization. To effectively identify and manage risks at all stages of the project, careful selection must be made at all levels of the ...

By Asl Maryam Tabatabay, Asl Saeedeh Tabababay

Harvest residues (HR) are one of the important aspects of sustainable management in agriculture, representing a significant portion of organic matter (OM) that can be retained or removed from agroecosystems. There are several ways to manage plant residues: (i) burning, (ii) incorporation in soil, (iii) leaving plant residues after harvest on the s...

By Novo Pržulj, Vesna Tunguz, Zoran Jovović, Ana Velimirović

Old-growth forests represent a very valuable field for research of natural processes. The application of remote sensing was carried out on two old-growth forests in the northwestern part of the Republic of Srpska. The sample plots from OG Janj show relatively higher mean values (NDVI, SAVI and EVI) compared to OG Lom, with the exception of the VARI...

By Zoran Govedar, Nemanja Anikić, Srđan Bilić

This paper presents research results of the Bugojno coal basin, which contains very significant, but still insufficiently explored lignite reserves. Based on the determined borders of surface distribution and the research results in the northwestern part of the Bugojno coal basin, proved are four coal layers with reserves of over one billion tons o...

By Dževad Forčaković, Rejhana Dervišević

The task was set, due to the capabilities of modern software systems, to assess the effect of the increase in inelastic deformations under prolonged load action on the loss of stability of thin-walled dome coverings. The study of the dependences of the forms of the loss of stability of dome covering from creep concrete that will help further with o...

By Sergey Gridnev, Ekaterina Prokshits, Olga Sotnikova, Iana Zolotukhina

This paper presents an analysis of water flow and flow velocity in an open channel of rectangular cross section as a function of channel roughness, ie Manning roughness coefficient. Three different cases of finishing the open channel of rectangular cross-section were analyzed, namely the concrete channel, the channel with smoothed cement mortar and...

By Nedim Suljić

This study presents results of chemical leaching of contaminated soil from several metallurgically loaded locality of Richnava in Slovakia, applying two chelants – Na2EDTA and Na3EDDS of different molar concentration, done at different leaching conditions. The lower molar concentration (2 mM) of chelants showed comparable effect on Mn, Ni, As...

By Zuzana Danková, Iveta Štyriaková, Ľubica Kovaničová, Katarína Čechovská, Marián Košuth, Jaroslav Šuba, Jarmila Nováková, Patrik Konečný, Ľubomír Tuček, Katarína Žecová, Eva Lenhardtová, Zoltán Németh

Chromium, ammonium, and potassium compounds are pollutants in the environment released mainly by industrial wastewater and they can negatively influence the quality of surface water. Zeolites and bentonites are commonly used adsorbents for removal of pollutant from water. In the study, the adsorbents were used in their natural form, without chemica...

By Tomáš Bakalár

The paper presents results of detailed geological research of quartzite in the wider area of Smrčevice, southeastern of Gornji Vakuf-Uskoplje. Based on the defined boundaries of surface distribution and research results, geological reserves of about 12 million tons have been determined in the wider area of Smrcevica. The quartzite reserves that hav...

By Dževad Forčaković, Rejhana Dervišević